KiteSurf Harness - Connect V3 Waist
NOTE : Included with Ozone Spreader bar V1
 |
Hard anodized Low Friction RingOur custom hard anodized Low Friction Ring is designed to fit the Click-In Loop – there is no need to change out the loop part on the Quick Release. Quick Release loops can also be used directly on the rope however this will increase friction and wear resulting in a shorter life span of parts. The high quality spliced Dyneema rope is ultra strong and long lasting, yet simple to replace when the time comes. |
Ergonomic fitThe ergonomic fit has an optimised mid section to increase back support without restricting movement. The Connect Waist Sliding harness is flexible in all directions so you feel completely unrestrained, this gives you extra freedom during manoeuvres and allows you to maintain a comfortable body position at all times. |
 |
 |
Ultra softUltra soft foam padding and an outer neoprene layer provide comfort with no rubbing points. Riding in board shorts is a rash/rub free experience thanks to the sleek lines and precise sculpted shape. |
Internal supportsInternal supports strengthen specific areas subject to higher loads combined with full length webbing between the spreader bar attachment points for optimum load distribution. |
 |
 |
Lightweight constructionA lightweight construction from only 930 grams (approx.) and the possibility to lay it flat without distorting pre-moulded or fixed shape panels make the Connect Waist the perfect travel harness. |
The Perfect FitWe recognise the need for a harness to match your body shape without compromise so we’ve made it available in a range of seven sizes to offer the perfect fit for everyone. The Connect Waist Sliding V3 is designed for a tight and close fit, the tighter you wear a harness the less tendency it will have to ride up or shift from side to side. This added security combined with the lightweight comfort allows you to stay out for longer and make the most of your sessions. |
 |